Four ways to deal with jitter in the operation of linear modules. With the advancement of science and technology, people's living standards have been greatly improved, and traditional assembly line operations have been gradually replaced by robots. As we all know, most robot parts are based on linear modules, driven by servo motors. What should I do when the machine is shaking? Let's listen to the analysis of Guangdong TICO automation engineers!

Screw drive is widely used in most application industries, and different screw speeds are different. What should I do if it shakes during operation? We can analyze it from the following points:

1. Remove the cover and check whether the screws of each part are loose. If it comes loose, lock it with a tool and check to see if it reappears.

2. Check the overall straightness of the guide rail and whether the position of the screw hole is offset or loose. If yes, reposition and lock the rail to ensure straightness;

3. Check nuts and screws for problems and remove them. In order to completely eliminate it, it is recommended to pull out the steel ball of the nut, re-adjust the nut to ensure uniform clearance, add appropriate lubricant to improve the finish, and re-install the nut for inspection.

4. Then check the bearing, support seat, fixed side and various components, reinstall the lock, and conduct a power-on test on the lock cover to see if the fault can be eliminated.

Generally speaking, the jitter of linear modules is mostly caused by direct problems of screws and nuts, which can basically be solved by disassembling and readjusting nuts, replacing steel balls and adding lubricating fluid. Of course, this is only one of them. If there is anything unclear in the actual operation, you can contact us at any time Guangdong TICO Automation Technology Co., Ltd.!